Lighting knowledge
Tags: LED lighting,environmentally-beneficial,energy-saving
Increasing carbon emissions is becoming an important issue for the global survival. We are trying to educate people about the cost-saving and environmental benefits of alternate systems for their regular uses which consumes less energy in their development and collectively they bring about an environmentally-beneficial outcome.
By switching to energy-saving LED light bulbs and applications
See more...
Tags: LED light, Technical parameters
Luminious Energy
Luminous energy is the perceived energy of light. This is cometiomes also called the quality of light.
Luminous flux (lm)
Luminous flux or luminous power is the measure of the perceived power of light. The SI unit of luminous flux is the lumen(lm). One lumen is defined as the luminous flux of light produced by a light source that emits one candela of luminous
See more...
Tags: LED flat light source
The advantages of LED flat light source is as follows: 1. Can be overcome line LED lights, LED high-power are the shortcomings of glare 2. To overcome the type of LED chip size, and the shortcomings of high cost 3. Attenuation using anti-aging material with 10 * 23MIL the large-size chips and sophisticated packaging technology that allows planar LED light source modules failure of less than
See more...
Tags: LED characteristics
LED determines the intrinsic characteristics of the light source it is best to replace the traditional light source, it has a wide range of functions. Small size Is basically a small LED chip is packaged in epoxy resin inside, so it is very small, very light. Low power consumption LED power consumption is very low, in general the work of LED voltage is 2-3.6V. Operating current is 0.02-0.03A.
See more...
Tags: LUX
Lux is lumen per square meter. According to Wikipedia, "The difference between the lux and the lumen is that the lux takes into account the area over which the luminous flux is spread. 1000 lumens, concentrated into an area of one square meter, lights up that square meter with an illuminance of 1000 lux. The same 1000 lumens, spread out over ten square meters, produces a dimmer illuminance of
See more...
Tags: lumen
Lumen is amount of light emitted from light source. According to Wikipedia, "If a light source emits one candela of luminous intensity into a solid angle of one steradian, the total luminous flux emitted into that solid angle is one lumen. Alternatively, an isotropic one-candela light source emits a total luminous flux of exactly 4?? lumens. The lumen can be thought of casually as a measure of
See more...
Tags: LED technologies, developing, compare
In the past, we have generally referred to the brightness of a bulb in terms of its wattage, or the amount of power that the bulb uses (or energy it consumes). Because of the disparity between incandescent and LED technologies, we have to change our language a bit in order to account for progress. When referring to brightness, we now find ourselves comparing lumens (see Q: What is a lumen?).
See more...
Tags: LED, LED lighting application
EVERYONE! Architects and lighting designers are specifying entire lighting packages in their new designs. Contractors are using them in everything from custom kitchens to retail stores. Many homeowners are replacing their incandescents with LED bulbs. LED lighting can replace every instance of old lighting technology, as well create entirely new lighting applications due to its versatility. Your
See more...
Tags: LED definitation,LED technology
LED lighting has been around for many years and is just now really coming into its own. For years, the Light Emitting Diode was simply used as an indicator or display light in various small-scale applications. Think of those old Texas Instruments calculators, or your blinking VCR light. LED is a solid-state technology. This means there is no glass bulb, no pressurized gases, no mercury and no
See more...
Tags: LED discovery, LED panel, LED
DiscoveryThe first known report of a light-emitting solid-state diode was made in 1907 by the British experimenter H. J. Round. However, no practical use was made of the discovery for several decades.[18] Independently, Oleg Vladimirovich Losev published "Luminous carborundum [[silicon carbide]] detector and detection with crystals" in the Russian journal Telegrafiya i Telefoniya bez Provodov
See more...
Tags: advantages, LED lighting, LED spot light
COMFORT - Designed to replace Halogen bulb. No need for modification(Certified Transformer only) - In case of new installation , no need for transformer installation.(Parallel connect to SMPS). - Optimum heat dissipation design DURABILITY - Reliable LED with ESD protection circuit. - Reliable against impact and vibration. - Far longer life time than Halogen bulb. More than 30,000 HRs.
See more...
Tags: solar light, maintenance
1) Periodically clean the top surface of the solar light unit for best energy collection.Do not put any pressure on the solar module during cleaning. Do not use solvents.2) It is receommend that the light be stored in winter, in a frost free, dry location, and re-ercted again in spring.3) It is recommend that you fully re-charge the batteries from time to time(every 3 months) for approx. 2 days
See more...
Tags: solar light, features
1) NO wiring required.2) Easy to install.3) Super bright LED bulbs.4) AA size NI-MH or NI-Cd 1.2 Volt rechargeable batteries.5) Batteries recharged by daylight using solar panels. 6) Fully charged batteries can provide up to 8 hours of light at night.7) Photocell activated. Light turns on automatically when
See more...
Tags: LED. green light source
LED is the most promising in recent years, the world's one of the areas of high-tech, LED has a long life, low power consumption, faster response to the volume of filial piety, seismic resistance at low temperature, pollution and other prominent advantages of small, known as the fourth-generation light source or green light source, will become the history of mankind following the incandescent
See more...
Tags: solar light, how to work
During the day, the solar panel converts the solar power into electricity and recharges the batteries. At night, solar light turns ON automatically with the electricity stored during the day. Some models have an ON/OFF switch, ensure this is in the "ON" position. The number of hours of illumination depends on the geographical location, weather conditions and seasonal lighting
See more...
Tags: technical requirements, testing, lighting products
1. High-pressure test2. Grounding resistance test3. Rally test (the power cord to leave lights or the location of the body when the spin-off packaging in-house wiring connection point) 4. Torque test 5. No. wire 6. Wire connections 7. Polar distinction 8. Open wire line to deal with 9. Off-line protection10. Universal shook his head, and other parts of the line have been transferred and
See more...
Tags: Lighting fixture,EN safety, testing
1. Lighting fixture: the distribution to all, revealing or changing one or more of the light source of light to issue an apparatus, and includes support, and protection of a fixed light source components necessary (but not its own light source), as well as the necessary circuitry and will assist device They connect with the power supply facilities. 2. General lighting fixture: to prevent
See more...
Tags: EN60598, EU Standard
EN60598-1:2000 Luminaires-Part 1:General requirements and texts.It contains the work of 0 ~ 1000V voltage lamps all safety requirements and test projectsEN60598-2-1:1989 Specification for fixed general purpose luminaries. EN60598-1 specified in the terms which apply to the general purpose of the lamp fixed at the same time that some of the special kind of lighting requirements.
See more...
Tags: RoHS
Member's country will insure, since July 1, 2006, new electronics and electricity equipments which throw in in the market don't include a lead, mercury, cadmium, six price chromes, gather bromine two benzene ether(PBDE)s or gather bromine biphenyl(PBB).Following row of the application be unwell to used for the above-mentioned provision: 1 the mercury content in the small scaled fluorescent lamp
See more...
Tags: EUP, EUROPEAN STANDARD
The EU Energy-Using Product Directive (EuP – 2005/32/EC) requires designers and manufacturers of energy-using products to apply eco-design principles to effectively reduce the environmental impact of their products from cradle-to-grave. The EuP Directive very broadly defines an energy-using product as: “a product which is dependent on energy input (electricity, fossil fuels and
See more...
Tags: LED, light decline, resolve way
LED light product failure is the light in the transmission signal weakened,
And at the present stage of global LED manufacturers have made the extent of bad light LED products are different, Similarly the existence of high-power LED light failure, which is directly related to temperature, mainly by the chip, phosphor and packaging technology decisions.
At present, the white LED
See more...
About Us: China Acmelite Electric Co., Limited is a professional and large-scale manufacturer and exporter of lighting fixtures in Zhejiang province, since 1997. We aim to offer the suitable lighting products and best services to our international customers, and help them to be more competitive and powerful in the global market.
Our main products include T2, T4, T5 and T8 lighting fixtures, halogen lighting fixtures and ceiling light fixtures, which are widely used in home & office, for commercial and industrial purpose as well. Most of the products have obtained Gs, CE, EMC, RoHS certificate and UL listing. They are popular in the global market, especially in North American and Europe. From year of 2007, we also developed two new product lines: Solar powered lighting and LED lighting. Please refer to www.acmelite.net for more details. More...